Features |
|
Wireless Temperature REM |
|
Datasheet are in PDF format and require Adobe Acrobat Reader |
|
· Wireless remote sensing of input points up to 20m (depending on obstructions) from the GENESIS REM network via a single 10kΩ thermistor temperature sensor, one digital pushbutton input and one analogue input (20kΩ potentiometer). · 3.6V DC battery operation. · Minimum 12 months battery life. · Low Battery indication available as a Digital Input in GEN2Config software. · RF Comms at 250kbaud. · Input values transmitted at 20 second intervals. · Pushbutton status change reported immediately. · Selectable “Transmit Test Mode” to aid installation. · Jumper selectable REM Network Address (1-15). · Jumper selectable RF Frequency (2400-2524MHz). · Wiring diagrams for modules generated by GEN2Config software. |
|
The Innotech SENRx series Wireless Temperature Sensors are remote expansion devices for the GENESIS range of Digital Controllers.
The SENRx modules are designed to be remotely located from the GENESIS Digital Controller and provide: a thermistor input for temperature measurement, a digital pushbutton input for after hours status detection, an analogue input for setpoint adjustment and a digital low battery indicator.
There are no physical connections to a SENRx module. A wireless communications protocol is used to transmit the input data to a GENII WMI Wireless Module Interface. The GENII WMI receives this information and relays it over the RS485 link that communicates with other REM Modules at 38.4kbaud. See the GENII WMI datasheet for further information. |
|
Innotech Controls America |
|
Innotech Control Systems |